Nitecore UCN1 – Canon LP-E6/E8 USB Charger

Professionally made to exceed expectations
Good riddance to the outdoor charging conundrum, breaking loose from technical constraints inherited in conventional camera charging.

Compatible with multiple inputs sources
Easily copes with situations where AC input is not possible. Compatible with an array of portable powerbanks, solar panels, USB adaptors, can be used in conjunction with Nitecore’s F1 flexible power bank to ensure endless power supply.
(Note: The F1 flexible power bank in conjuncion with a fully charged 18650 battery holds enough charge to fully charge 1-2 camera batteries)

Dual Slot charger
Dual slot charger specifically designed for enthusiasts, tending to the needs of both primary and backup cameras.
Slot on front and bottom facades. Thoughful design to accommodate the needs for enthusiastic photographers who cary a primary and backup cameras, eliminating concerns for power shortage for either camera.

Smart charging management system
The UNC1takes advantages of the smart charging management system; it monitors battery status, displaying battery voltage, charging current, charging temperature and charged volume, and automatic adoption for the optimal charging modes between CC and CV.

Battery status monitoring
Once the battery is inserted, the UCN1 will proceed with a initial low current test charge to diagnose battery status. Afte the diagnosis, battery status will be shown as Good, Normal or Poor.

Battery recovery
The UCN1 will attempt to recover over-discharged batteries when inserting in the charging slot. Upon successful battery recovery, the entire battery level indicator will flash to represent that a battery has been successfully recovered.
This feature only works with protected batteries.

Reverse polarity and anti-short circuit protection
The UCN1 makes use of the mechanical reverse polariy protection. Inserting incompatible batteries or incorrect battery installation will prevent te initiation of the charging process. The error message “EE EE” will come up on the LC display when a short circuited battery is installed.

Input
DC 5V/2A

Output voltage
Slot 1 (LP-E6/LP-E6N) 8.4V
Slot 2 (LP-E8) 8.4V

Output current
1000mA (MAX)

Battery compatibility
Canon camera batteries ( LP-E6/LP-E6N and LP-E8)

LP-E6/LP-E6N compatible models:
Canon EOS 5D Mark II, Canon EOS 5D Mark III, Canon EOS 5DS,
Canon EOS 5DS R, Canon EOS 6D, Canon EOS 7D, 6D Mark II, 5D Mark IV, 80D, Canon EOS 7D Mark II, Canon EOS 60D, Canon EOS 60Da,
Canon EOS 70D, Canon XC10, Canon EOS 5D Mark IIII
LP-E8 compatible models:
Canon EOS Rebel T2i, Canon EOS Rebel T3i, Canon EOS Rebel T4i,
Canon EOS Rebel T5i, Canon EOS 550D, Canon EOS 600D,
Canon EOS 650D, Canon EOS 700D, 650D，550D， Canon EOS Kiss X4,
Canon EOS Kiss X5, Canon EOS Kiss X6